NWA Managed Access Point Series USER’S GUIDE NWA5160N 802.11a/g/n Wireless LAN Managed Access Point NWA5560-N 802.11 a/b/g/n DualRadio Managed Access Point Version 1.00 Edition 1, 05/2011 www.zyxel.
Device Panels KENSINGTON LOCK RESET CONSOLE PORT WLAN OR WLAN 1/2 2 ETHERNET POWER PORT JACK POWER / SYS ETHERNET
NWA Managed Access Point User’s Guide LEDs The following table describes your NWA’s (Managed Access Point) LEDs. LED Color STATE DESCRIPTION Power / Sys Green On The NWA is powered on. Off The NWA is powered off. Off The NWA has succesfully booted. Flashing The NWA has encountered a system failure and cannot boot. Green Flashing / On The NWA has an active 10M/100M connection. Yellow Flashing / On The NWA has an active 1000M connection.
NWA Managed Access Point User’s Guide With PoE 1. Connect the NWA to a PoE device with an 8-pin CAT5e cable. 2. Connect the PoE device to an upstream switch or directly to the NXC5200 Wireless LAN Controller.
NWA Managed Access Point User’s Guide Without PoE 1. Connect the NWA to to an upstream switch or directly to the NXC5200 Wireless LAN Controller. 2. Connect the NWA to an appropriate power outlet and turn on the power. Console Port Configuration The NWA is pre-configured, but you may use the console port to manually configure the NWA if necessary. Connect a PS-2 console cable from the console port on your computer to the console port on your NWA.
NWA Managed Access Point User’s Guide • Speed 115,200 bits per second • 8 data bits, no parity, 1 stop bit • No flow control. Log in using ‘admin’ and ‘1234’ as the username and password. Welcome to NWA5560-N Username: admin Password: NWA IP Address The NWA is pre-configured to get a dynamic IP address from a DHCP server by default. Use these commands if you want to give the NWA a fixed IP address. Router# configure terminal Router(config)# capwap ap vlan ip address 192.168.1.37 255.255.255.
NWA Managed Access Point User’s Guide Static Discovery Manually enter the IP address of the NXC on the NWA. You can enter up to two IP addresses for the NXC. Router# configure terminal Router(config)# capwap ap ac-ip 192.168.1.1 192.168.1.2 Router(config)# show capwap ap discovery-type Discovery type : Static AC IP Enter configuration mode These are the NXC IP addresses Confirm that static discovery is used to find the NXC. AC is the AP Controller, that is, the NXC.
NWA Managed Access Point User’s Guide For example: Router# configure terminal Router(config)# capwap ap vlan vlan-id 2 tag To see detailed NWA – NXC connection status, use the following command: Router# show capwap ap info SM-State msg-buf-usage capwap-version Radio Number BSS Number IANA ID Description RUN(8) 0/10 (Usage/Max) 10118 1/4 (Usage/Max) 8/8 (Usage/Max) 037a AP-0013499999FF Specifications Specifications are accurate at the time of writing.
NWA Managed Access Point User’s Guide Feature Specification Temperature NWA5160N: Operating: 0~40 oC, Storage: -30~60 oC NWA5560-N: Operating: 0~40 oC, Storage: -30~70 oC Humidity NWA5160N: Operating: 20~95 oC, Storage: 20~95 oC NWA5560-N: Operating: 10~90 oC, Storage: 10~90 oC Standards Compliance IEEE 802.3 & 802.3u 10Base-T & 100Base-TX physical layer specification IEEE 802.3ab (1000BASE-T) IEEE 802.3z (1000Base-SX/ 1000Base-LX) IEEE 802.11a IEEE 802.11b IEEE 802.11g IEEE 802.11n IEEE 802.
NWA Managed Access Point User’s Guide Feature Specification Output Power 2.4GHz • • • • • IEEE IEEE IEEE IEEE IEEE 802.11b/g 17dBm max. 802.11b/g/n (HT20 only) 17dBm max 5GHz 802.11a 18dBm max. 802.11a/n HT20 7dBm max 802.11a/n HT40 13dBm max Safety Approvals European Union EMI Approvals European Union (CE Mark) • EN 60950-1 • EN 301 489-1 V1.8.1 • EN 301 489-17 V2.1.
NWA Managed Access Point User’s Guide Wall Mounting Instructions Do not install the NWA in an inverted horizontal position under a desk or tabletop. To hang your NWA on a wall: 1. Select a position free of obstructions on a sturdy wall. 2. Drill two pilot holes for the screws. Make sure the distance between the centers of the holes and the size of screws match the specifications below. Be careful to avoid damaging pipes or cables located inside the wall when drilling holes for the screws.
NWA Managed Access Point User’s Guide 3. Do not screw the screws all the way into the wall. Leave a small gap of about 0.5 cm between the heads of the screws and the wall. 4. Make sure the screws are snugly fastened to the wall. They need to hold the weight of the NWA with the connection cables. 5. Align the holes on the back of the NWA with the screws on the wall. Hang the NWA on the screws.
NWA Managed Access Point User’s Guide • • • • • • • • • • • • points or other risks. ONLY qualified service personnel should service or disassemble this device. Please contact your vendor for further information. Make sure to connect the cables to the correct ports. Place connecting cables carefully so that no one will step on them or stumble over them. Always disconnect all cables from this device before servicing or disassembling. Use ONLY an appropriate power adaptor or cord for your device.
NWA Managed Access Point User’s Guide equipment should be installed and operated with minimum distance 20cm between the radiator & your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. Operations in the 5.15-5.25GHz band are restricted to indoor usage only.
NWA Managed Access Point User’s Guide Note Repair or replacement, as provided under this warranty, is the exclusive remedy of the purchaser. This warranty is in lieu of all other warranties, express or implied, including any implied warranty of merchantability or fitness for a particular use or purpose. ZyXEL shall in no event be held liable for indirect or consequential damages of any kind to the purchaser.
NWA Managed Access Point User’s Guide 16
