Operation Manual

Chapter 6 Provisioning User Interfaces

OLT2406 User’s Guide

3 Enable the MDU’s VDSL2 port (port 1 in this example) and check the status.

4 Configure VLAN flow settings for the VDSL port on the remote ONT the same as in step 9 on page

64 except it’s for ONT 102.

OLT2406# config

OLT2406(config)# remote ontvdsl ontvdsl-6-1-102-1-1

OLT2406(config-ontvdsl)# no inactive

OLT2406(config-ontvdsl)# exit

OLT2406(config)# exit

OLT2406# show remote ontvdsl line-template ontvdsl-6-1-102-1-1

------------------------------------------------------------------------------

ontvdsl-6-1-102-1-1: line template = DEFVAL

------------------------------------------------------------------------------

OLT2406(config)# remote uniport uniport-6-1-102-1-1

OLT2406(config-remote-uniport)# queue tc 1 priority 1 weight 0 usbwprofname voice dsbwprofname voice bwsharegroupid 1

OLT2406(config-remote-uniport)# vlan 10 network 10 ingprof voip aesencrypt disable active on

OLT2406(config-remote-uniport)# exit

OLT2406(config)# exit

OLT2406# show remote uniport uniport-6-1-102-1-1 queue

Uniport TrafficClass Priority Weight UsBwProfileName DsBwProfileName BwShareGroupId

-------------------------------------------------------------------------------------------------

uniport-6-1-101-1-1 1 2 0 voice voice 1

OLT2406# show remote uniport uniport-6-1-102-1-1 vlan 10

|AID | UNI-VID Status NNI-VID Tag PBit_Prof DSCP_to_PBIT Ing_Prof TC GemP AES_Ept

----------------------+------------------------------------------------------------------------------------------------------

v|uniport-6-1-102-1-1 | 10 Idle 10 tag inactive voip 1 256 disable

----------------------+------------------------------------------------------------------------------------------------------