User's Manual

Chapter 6 WAN Setup
P-2612HW Series User’s Guide
110
6.3.2 Configuring More Connections Advanced Setup
To edit your ZyXEL Device's advanced WAN settings, click the Advanced Setup
button in the More Connections Edit screen. The screen appears as shown.
Figure 78 Network > WAN > More Connections: Edit: Advanced Setup
The following table describes the labels in this screen.
Table 23 Network > WAN > More Connections: Edit: Advanced Setup
LABEL DESCRIPTION
RIP & Multicast Setup This section is not available when you configure the ZyXEL Device
to be in bridge mode.
RIP Direction Select the RIP direction from None, Both, In Only and Out
Only.
RIP Version Select the RIP version from RIP-1, RIP-2B and RIP-2M.
Multicast IGMP (Internet Group Multicast Protocol) is a network-layer
protocol used to establish membership in a multicast group. The
ZyXEL Device supports both IGMP version 1 (IGMP-v1) and
IGMP-v2. Select None to disable it.
ATM QoS
ATM QoS Type Select CBR (Continuous Bit Rate) to specify fixed (always-on)
bandwidth for voice or data traffic.
Select UBR (Unspecified Bit Rate) for applications that are non-
time sensitive, such as e-mail.
Select VBR-RT (real-time Variable Bit Rate) type for applications
with bursty connections that require closely controlled delay and
delay variation.
Select VBR-nRT (non real-time Variable Bit Rate) type for
connections that do not require closely controlled delay and delay
variation.