User's Manual

Chapter 7 LAN Setup
P-2612HW Series User’s Guide
123
and subnet mask of your ZyXEL Device and configure the DNS server information
that the ZyXEL Device sends to the DHCP client devices on the LAN.
Figure 83 Network > LAN > IP
The following table describes the fields in this screen.
Table 25 Network > LAN > IP
LABEL DESCRIPTION
LAN TCP/IP
IP Address Enter the LAN IP address you want to assign to your ZyXEL Device in
dotted decimal notation, for example, 192.168.1.1 (factory default).
IP Subnet Mask Type the subnet mask of your network in dotted decimal notation, for
example 255.255.255.0 (factory default). Your ZyXEL Device
automatically computes the subnet mask based on the IP address you
enter, so do not change this field unless you are instructed to do so.
DHCP Setup
DHCP If set to Server, your ZyXEL Device can assign IP addresses, an IP
default gateway and DNS servers to LAN computers and other devices
that are DHCP clients.
If set to None, the DHCP server will be disabled. You need to manually
configure the IP addresses of the computers and other devices on your
LAN.
If set to Relay, the ZyXEL Device acts as a surrogate DHCP server and
relays DHCP requests and responses between the remote server and
the clients. Enter the IP address of the actual, remote DHCP server in
the Remote DHCP Server field in this case.
When DHCP is used, the following items need to be set: