User's Manual

Chapter 1 Introducing the ZyXEL Device
P-2612HW Series User’s Guide
30
configuration file. This means that you will lose all configurations that you had
previously and the passwords will be reset to the defaults.
1 Make sure the POWER LED is on (not blinking).
2 To set the device back to the factory default settings, press the RESET button for
ten seconds or until the POWER LED begins to blink and then release it. When the
POWER LED begins to blink, the defaults have been restored and the device
restarts.
1.6 The WLAN Button
Use the WLAN button ( ) on the top of the device to turn the wireless LAN off
or on. Make sure the POWER LED is on (not blinking) before using the WLAN
button.
•Press the WLAN button for one second and release it. The WLAN LED should
change from on to off or vice versa.
• Press the WLAN button for five seconds to turn on WPS. See Section 8.9.5.1 on
page 161 for more on using WPS to configure your wireless clients.