User's Manual

Chapter 18 Quality of Service (QoS)
P-2612HW Series User’s Guide
347
802.1Q Tag Select Same to keep the priority setting and VLAN ID of the frames.
Select Auto to map the 802.1 priority level to the DSCP value
automatically.
Select Remove to delete the priority queue tag and VLAN ID of the
frames.
Select Mark to replace the 802.1 priority field and VLAN ID with the
value you set in the fields below.
Select Add to treat all matched traffic untagged and add a second
priority queue tag and VLAN.
Ethernet
Priority
Select a priority level (between 0 and 7) from the drop down list box.
VLAN ID Specify a VLAN ID number between 2 and 4094.
Filter
Configuration
Use the following fields to configure the criteria for traffic
classification.
Source
Address Select the check box and enter the source IP address in dotted
decimal notation. A blank source IP address means any source IP
address.
Subnet
Netmask
Enter the source subnet mask. Refer to the appendix for more
information on IP subnetting.
Port Select the check box and enter the port number of the source. 0
means any source port number. See Appendix E on page 531 for some
common services and port numbers.
MAC Select the check box and enter the source MAC address of the packet.
MAC Mask Type the mask for the specified MAC address to determine which bits
a packet’s MAC address should match.
Enter “f” for each bit of the specified source MAC address that the
traffic’s MAC address should match. Enter “0” for the bit(s) of the
matched traffic’s MAC address, which can be of any hexadecimal
character(s). For example, if you set the MAC address to
00:13:49:00:00:00 and the mask to ff:ff:ff:00:00:00, a packet with a
MAC address of 00:13:49:12:34:56 matches this criteria.
Exclude Select this option to exclude the packets that match the specified
criteria from this classifier.
Destination
Address Select the check box and enter the destination IP address in dotted
decimal notation.
Subnet
Netmask
Enter the destination subnet mask. Refer to the appendix for more
information on IP subnetting.
Port Select the check box and enter the port number of the destination. 0
means any source port number. See Appendix E on page 531 for some
common services and port numbers.
MAC Select the check box and enter the destination MAC address of the
packet.
Table 114 Advanced > QoS > Class Setup > Add (continued)
LABEL DESCRIPTION