User's Manual

Chapter 20 Remote Management Configuration
P-2612HW Series User’s Guide
359
Remote Management and NAT
When NAT is enabled:
• Use the ZyXEL Device’s WAN IP address when configuring from the WAN.
• Use the ZyXEL Device’s LAN IP address when configuring from the LAN.
System Timeout
There is a default system management idle timeout of five minutes (three
hundred seconds). The ZyXEL Device automatically logs you out if the
management session remains idle for longer than this timeout period. The
management session does not time out when a statistics screen is polling.
20.2 The WWW Screen
To change your ZyXEL Device’s World Wide Web settings, click Advanced >
Remote MGMT to display the WWW screen.
Figure 210 Advanced > Remote Management > WWW
The following table describes the labels in this screen.
Table 119 Advanced > Remote Management > WWW
LABEL DESCRIPTION
Port You may change the server port number for a service if needed,
however you must use the same port number in order to use that
service for remote management.
Access Status Select the interface(s) through which a computer may access the ZyXEL
Device using this service.