User's Manual

Chapter 20 Remote Management Configuration
P-2612HW Series User’s Guide
360
20.3 The Telnet Screen
You can use Telnet to access the ZyXEL Device’s command line interface. Specify
which interfaces allow Telnet access and from which IP address the access can
come. Click Advanced > Remote MGMT > Telnet tab to display the screen as
shown.
Figure 211 Advanced > Remote Management > Telnet
The following table describes the labels in this screen.
Secured Client
IP
A secured client is a “trusted” computer that is allowed to communicate
with the ZyXEL Device using this service.
Select All to allow any computer to access the ZyXEL Device using this
service.
Choose Selected to just allow the computer with the IP address that
you specify to access the ZyXEL Device using this service.
Apply Click Apply to save your settings back to the ZyXEL Device.
Cancel Click Cancel to begin configuring this screen afresh.
Table 119 Advanced > Remote Management > WWW
LABEL DESCRIPTION
Table 120 Advanced > Remote Management > Telnet
LABEL DESCRIPTION
Port You may change the server port number for a service if needed, however
you must use the same port number in order to use that service for
remote management.
Access Status Select the interface(s) through which a computer may access the ZyXEL
Device using this service.