User's Manual

Chapter 20 Remote Management Configuration
P-2612HW Series User’s Guide
364
20.5.1 Configuring SNMP
To change your ZyXEL Device’s SNMP settings, click Advanced > Remote MGMT
> SNMP. The screen appears as shown.
Figure 214 Advanced > Remote Management > SNMP
The following table describes the labels in this screen.
6a For intentional reboot: A trap is sent with the message "System reboot
by user!" if reboot is done intentionally, (for
example, download new files, CI command "sys
reboot").
6b For fatal error: A trap is sent with the message of the fatal
code if the system reboots because of fatal
errors.
Table 122 SNMP Traps
TRAP #
TRAP NAME DESCRIPTION
Table 123 Advanced > Remote Management > SNMP
LABEL DESCRIPTION
SNMP
Port You may change the server port number for a service if needed,
however you must use the same port number in order to use that
service for remote management.
Access Status Select the interface(s) through which a computer may access the
ZyXEL Device using this service.