User's Manual

Chapter 25 Tools
P-2612HW Series User’s Guide
415
1 The firewall is active (turn the firewall off or create a firewall rule to allow access
from the WAN).
2 You have disabled the FTP service in the Remote Management screen.
3 The IP you entered in the Secured Client IP field does not match the client IP. If it
does not match, the device will disallow the FTP session immediately.
25.1.3 Before You Begin
• Ensure you have either created a firewall rule to allow access from the WAN or
turned the firewall off, otherwise the FTP will not function.
• Make sure the FTP service has not been disabled in the Remote Management
screen.
25.1.4 Tool Examples
Using FTP or TFTP to Restore Configuration
This example shows you how to restore a previously saved configuration. Note
that this function erases the current configuration before restoring a previous back
up configuration; please do not attempt to restore unless you have a backup
configuration file stored on disk.
FTP is the preferred method for restoring your current computer configuration to
your device since FTP is faster. Please note that you must wait for the system to
automatically restart after the file transfer is complete.
Do not interrupt the file transfer process as this may
PERMANENTLY DAMAGE your device. When the Restore
Configuration process is complete, the device automatically
restarts.
Restore Using FTP Session Example
Figure 240 Restore Using FTP Session Example
Refer to Section 25.1.2 on page 413 to read about configurations that disallow
TFTP and FTP over WAN.
ftp> put config.rom rom-0
200 Port command okay
150 Opening data connection for STOR rom-0
226 File received OK
221 Goodbye for writing flash
ftp: 16384 bytes sent in 0.06Seconds 273.07Kbytes/sec.
ftp>quit