User's Manual

Chapter 25 Tools

P-2612HW Series User’s Guide

427

25.5.2 FTP Command Configuration Backup Example

This figure gives an example of using FTP commands from the DOS command

prompt to save your device’s configuration onto your computer.

Figure 254 FTP Session Example

25.5.3 Configuration Backup Using GUI-based FTP Clients

The following table describes some of the commands that you may see in GUI-

based FTP clients.

25.5.4 Backup Configuration Using TFTP

The ZyXEL Device supports the up/downloading of the firmware and the

configuration file using TFTP (Trivial File Transfer Protocol) over LAN. Although

TFTP should work over WAN as well, it is not recommended.

331 Enter PASS command

Password:

230 Logged in

ftp> bin

200 Type I OK

ftp> get rom-0 zyxel.rom

200 Port command okay

150 Opening data connection for STOR ras

226 File received OK

ftp: 16384 bytes sent in 1.10Seconds 297.89Kbytes/sec.

ftp> quit

Table 160 General Commands for GUI-based FTP Clients

COMMAND DESCRIPTION

Host Address Enter the address of the host server.

This is when a user I.D. and password is automatically supplied

to the server for anonymous access. Anonymous logins will work

only if your ISP or service administrator has enabled this option.

Normal.

The server requires a unique User ID and Password to login.

Transfer Type Transfer files in either ASCII (plain text format) or in binary

mode.

Initial Remote