User's Manual

Chapter 3 Wizards
P-2612HW Series User’s Guide
44
Note: When you use the connection wizard to configure the Internet access using
PPPoE, the ZyXEL Device is set to get an IP address from the ISP
automatically. To set up a static WAN IP address with PPPoE, use the Network
> WAN screen.
Figure 11 Internet Connection with PPPoE
The following table describes the fields in this screen.
Table 5 Internet Connection with PPPoE
LABEL DESCRIPTION
User Name Enter the user name exactly as your ISP assigned. If assigned a name in
the form user@domain where domain identifies a service name, then enter
both components exactly as given.
Password Enter the password associated with the user name above.
Back Click Back to go back to the previous wizard screen.
Apply Click Apply to save your changes back to the ZyXEL Device.
Exit Click Exit to close the wizard screen without saving your changes.