User's Manual

Chapter 14 Access Control
P-660RU-Tx User’s Guide
117
Application Select the service through which the computer can access the device.
• If you want to allow a user to connect to the P-660RU-Tx using the
web configurator, select Web.
• If you want to allow a user to connect to the P-660RU-Tx using Telnet,
select Telnet.
• If you want to allow a user to upload firmware to the P-660RU-Tx,
select FTP.
• If you want to allow an administrator to send SNMP commands, select
SNMP.
• If you want to allow a user to find the P-660RU-Tx on the network (for
troubleshooting purposes, for example), select Ping.
•Select ALL to allow access for all services. You cannot select a
combination of services.
Interface Select the port through which you can access the device. Select Both for
access via either port. If you configure 0.0.0.0 ~ 0.0.0.0 Secure IP
Address, ALL services and WAN interface, you will not be able to access
the device at all from the LAN unless you configure another rule for LAN
access.
Access
Control
Listing
The summary table displays the configured parameters for the selected
rule.
SAVE Click this so save your changes.
DELETE Select an access control rule index number and click this to remove it.
CANCEL Click this to restore your previously saved settings.
Table 33 Access Management > ACL (continued)
LABEL DESCRIPTION