User's Manual

Chapter 22 Firmware
P-660RU-Tx User’s Guide
154
FTP File Upload Command from the DOS Prompt Example
1 Launch the FTP client on your computer.
2 Enter “open”, followed by a space and the IP address of your device.
3 Press [ENTER] when prompted for a username.
4 Enter your password as requested (the default is “1234”).
5 Enter “bin” to set transfer mode to binary.
6 Use “put” to transfer files from the computer to the device, for example, “put
firmware.bin ras” transfers the firmware on your computer (firmware.bin) to the
device and renames it “ras”. Similarly, “put config.rom rom-0” transfers the
configuration file on your computer (config.rom) to the device and renames it
“rom-0”. Likewise “get rom-0 config.rom” transfers the configuration file on the
device to your computer and renames it “config.rom.” See earlier in this chapter
for more information on filename conventions.
7 Enter “quit” to exit the ftp prompt.
FTP Session Example of Firmware File Upload
Figure 73 FTP Session Example of Firmware File Upload
More commands (found in GUI-based FTP clients) are listed in this chapter.
Refer to Section 22.1.1 on page 151 to read about configurations that disallow
TFTP and FTP over WAN.
TFTP File Upload
The device also supports the uploading of firmware files using TFTP (Trivial File
Transfer Protocol) over LAN. Although TFTP should work over WAN as well, it is not
recommended.
331 Enter PASS command
Password:
230 Logged in
ftp> bin
200 Type I OK
ftp> put firmware.bin ras
200 Port command okay
150 Opening data connection for STOR ras
226 File received OK
ftp: 1103936 bytes sent in 1.10Seconds 297.89Kbytes/sec.
ftp> quit