User's Manual

Chapter 8 LAN Setup
P-660RU-Tx User’s Guide
77
8.2 The LAN Screen
Use this screen to configure your LAN settings. Click Interface Setup > LAN to
display the following screen.
Follow these steps to configure your LAN settings.
1 Enter an IP address into the IP Address field. The IP address must be in dotted
decimal notation. This will become the IP address of your P-660RU-Tx.
2 Enter the IP subnet mask into the IP Subnet Mask field. Unless instructed
otherwise it is best to leave this alone, the configurator will automatically compute
a subnet mask based upon the IP address you entered.
3 Click SAVE to save your settings.
Figure 28 Interface Setup > LAN
The following table describes the fields in this screen.
Table 17 Interface Setup > LAN
LABEL DESCRIPTION
Router Local IP
IP Address Enter the LAN IP address you want to assign to your P-660RU-Tx in
dotted decimal notation, for example, 192.168.1.1 (factory default).
IP Subnet Mask Type the subnet mask of your network in dotted decimal notation, for
example 255.255.255.0 (factory default). Your P-660RU-Tx
automatically computes the subnet mask based on the IP Address you
enter, so do not change this field unless you are instructed to do so.