Owner's Manual

Chapter 3 The ENCRYPT Button
PLA4215 User’s Guide
22
2 Press the ENCRYPT button at the side of your powerline device for 1~2 seconds. The power ( )
light will blink as the powerline device tries to set up a connection.
Figure 7 ENCRYPT Connection Procedure
Note: The ENCRYPT button’s location varies for each Powerline model.
3 Repeat step 2 in this section for the other powerline device you wish to connect. This must be done
within 120 seconds of pressing the ENCRYPT button on the PLA4215.
Note: Check the lights on the two powerline devices. The power ( ) and HomePlug ( )
lights should be blinking while the devices are connecting. Several times all lights
blink simultaneously and the HomePlug ( ) light also shows red. Wait for about
one minute while your powerline devices connect.
If the power ( ) light does not blink when you press ENCRYPT, you have probably pressed
the ENCRYPT button for too long. Try again, pressing the ENCRYPT button for 1~ 2
seconds.
If the HomePlug ( ) lights on both powerline devices do not light up, the powerline
devices are not connected. Repeat steps 2 and 3 in this section. If that doesn’t work, see
the Troubleshooting in Section 6.5 on page 51 for suggestions.
4 To add more powerline devices to your network, press the ENCRYPT button on device C (shown
below) for more than 10 seconds until the power ( ) light flashes.
press 2 seconds
press 2 seconds
within 2
minutes