Operation Manual

Chapter 12 Interface Group/VLAN
SBG3300-N Series User’s Guide
170
The following table describes the fields in this screen.
12.2.1 Interface Group Configuration
Click the Add New Interface Group button in the Interface Group screen to open the following
screen. Use this screen to create a new interface group.
Note: An untagged interface can belong to only one group at a time."
Figure 94 Interface Group Configuration
Table 69 Network Setting > Interface Group/VLAN
LABEL DESCRIPTION
Add New
Interface Group
Click this button to create a new interface group.
Status The icon shows whether the interface group is active or not. An inactive interface group
does not pass or accept traffic through its member ports. A yellow bulb signifies an active
interface group. A gray bulb signifies an inactive interface group. Click the bulb icon to
toggle the state of the interface group. The Default group cannot be inactive.
Group Name This shows the descriptive name of the group.
802.1q This shows the IEEE 802.1q VLAN ID number assigned to traffic sent through tagged
member ports of this group.
IPv4 This shows the IP address of the Device and the subnet mask for the LAN bridge interface
created by this group.
Port Members This shows the LAN interfaces (Ethernet LAN or wireless LAN) in the group and whether they
are tagged or untagged.
Modify Click the Edit icon to configure the group’s settings. Click the Delete icon to remove the
group.