Operation Manual

Chapter 1 Introducing the Device
SBG3300-N Series User’s Guide
21
1.6 The RESET Button
If you forget your password or cannot access the web configurator, you will need to use the RESET
button at the back of the device to reload the factory-default configuration file. This means that you
will lose all configurations that you had previously and the password will be reset to “1234”.
1 Make sure the POWER LED is on (not blinking).
2 To set the device back to the factory default settings, press the RESET button for ten seconds or
until the POWER LED begins to blink and then release it. When the POWER LED begins to blink,
the defaults have been restored and the device restarts.
1.7 Wireless Access
The Device is a wireless Access Point (AP) for wireless clients, such as notebooks, smartphones, or
tablets. It allows them to connect to the Internet without having to rely on inconvenient Ethernet
cables.
MOBILE Green On The 3G WAN connection is working.
Blinking The Device is sending or receiving data to/from the 3G WAN connection.
Off There is no 3G WAN connection.
USB Green On The Device recognizes a USB connection.
Blinking The Device is sending/receiving data to /from the USB device connected
to it.
Off The Device does not detect a USB connection.
WLAN/WPS Green On The wireless network is activated.
Blinking The Device is communicating with other wireless clients.
Green
and
Orange
Blinking The Device is setting up a WPS connection.
Off The wireless network is not activated.
Table 1 LED Descriptions (continued)
LED COLOR STATUS DESCRIPTION