Operation Manual

Chapter 5 Broadband
SBG3300-N Series User’s Guide
55
5.3 The 3G WAN Screen
Use this screen to configure your 3G settings. Click Network Setting > Broadband > 3G WAN.
Note: The actual data rate you obtain varies depending on the 3G USB dongle you use,
the signal strength to the service provider’s base station, and so on.
Sustainable Cell
Rate
The Sustainable Cell Rate (SCR) sets the average cell rate (long-term) that can be
transmitted. Type the SCR, which must be less than the PCR. Note that system default is 0
cells/sec.
This field is available only when you select Non Realtime VBR or Realtime VBR.
Maximum Burst
Size
Maximum Burst Size (MBS) refers to the maximum number of cells that can be sent at the
peak rate. Type the MBS, which is less than 65535.
This field is available only when you select Non Realtime VBR or Realtime VBR.
QoS
Rate Limit Enter the rate limit for the connection. This is the maximum transmission rate allowed for
traffic on this connection.
Apply Click Apply to save your changes.
Cancel Click Cancel to exit this screen without saving.
Table 9 Bridge Mode (ADSL over ATM) (continued)
LABEL DESCRIPTION