Operation Manual

Chapter 5 Broadband

SBG3300-N Series User’s Guide

5.7 The multi-WAN Screen

Use the multi-WAN screen to configure the multiple WAN load balance and failover rules to

distribute traffic among different interfaces. This helps to increase overall network throughput and

reliability. Load balancing divides traffic loads between multiple interfaces. This allows you to

improve quality of service and maximize bandwidth utilization for multiple ISP links.

You can only configure one rule for each interface. Click Network Setting > Broadband > multi-

WAN to display the following screen.

Figure 31 Network Setting > Broadband > multi-WAN

The following table describes the labels in this screen.

EAP method This is the EAP method used for this authentication.

Enable

Bidirectional

Authentication

Select this to allow bidirectional authentication.

Certificate Select the certificate you want to assign to the authentication. You need to import the

certificate in the Security > Certificates > Local Certificates screen.

Trusted CA Select the Trusted CA you want to assign to the authentication. You need to import the

certificate in the Security > Certificates > Trusted CA screen.

Apply Click Apply to save your changes.

Cancel Click Cancel to exit this screen without saving.

Table 15 802.1x: Add/Edit (Sheet 2 of 2)

LABEL DESCRIPTION

Table 16 Network Setting > Network Setting > multi-WAN

LABEL DESCRIPTION

Add New Entry Click this button to add a previously removed multi-WAN rule entry. By default, adding new

WAN interfaces to the system will generate a corresponding rule entry on this page in active

mode with a weight of 1. Each interface can have only one rule. If the interface you want to

configure already has a rule, you can edit it, or you can delete it before configuring a new

rule.

# This is the index number of the entry.

Interface This is the interface that uses the rule.

Mode This shows whether the rule is Active or Passive.

Weight This shows the weight of the rule.

Modify Click the Edit icon to configure the multi-WAN rule.

Click the Delete icon to remove the multi-WAN rule.