Operation Manual
Table Of Contents
- VMG4825-B10A
- User’s Guide
- Introducing the VMG
- The Web Configurator
- Quick Start
- Tutorials
- 4.1 Overview
- 4.2 Setting Up an ADSL PPPoE Connection
- 4.3 Setting Up a Secure Wireless Network
- 4.4 Setting Up Multiple Wireless Groups
- 4.5 Configuring Static Route for Routing to Another Network
- 4.6 Configuring QoS Queue and Class Setup
- 4.7 Access the VMG Using DDNS
- 4.8 Configuring the MAC Address Filter
- 4.9 Access Your Shared Files From a Computer
- Technical Reference
- Network Map and Status Screens
- Broadband
- Wireless
- Home Networking
- Routing
- Quality of Service (QoS)
- Network Address Translation (NAT)
- Dynamic DNS Setup
- VLAN Group
- Interface Grouping
- USB Service
- Firewall
- MAC Filter
- Parental Control
- Scheduler Rule
- Certificates
- Log
- Traffic Status
- ARP Table
- Routing Table
- Multicast Status
- xDSL Statistics
- System
- User Account
- Remote Management
- SNMP
- Time Settings
- E-mail Notification
- Log Setting
- Firmware Upgrade
- Backup/Restore
- Diagnostic
- Troubleshooting
- Appendices
Chapter 7 Wireless
VMG4825-B10A User’s Guide
110
access point is the WPS registrar, the enrollee, or was not involved in the WPS handshake; a
rogue device must still associate with the access point to gain access to the network. Check the
MAC addresses of your wireless clients (usually printed on a label on the bottom of the device). If
there is an unknown MAC address you can remove it or reset the AP.