Operation Manual
Table Of Contents
- VMG4825-B10A
- User’s Guide
- Introducing the VMG
- The Web Configurator
- Quick Start
- Tutorials
- 4.1 Overview
- 4.2 Setting Up an ADSL PPPoE Connection
- 4.3 Setting Up a Secure Wireless Network
- 4.4 Setting Up Multiple Wireless Groups
- 4.5 Configuring Static Route for Routing to Another Network
- 4.6 Configuring QoS Queue and Class Setup
- 4.7 Access the VMG Using DDNS
- 4.8 Configuring the MAC Address Filter
- 4.9 Access Your Shared Files From a Computer
- Technical Reference
- Network Map and Status Screens
- Broadband
- Wireless
- Home Networking
- Routing
- Quality of Service (QoS)
- Network Address Translation (NAT)
- Dynamic DNS Setup
- VLAN Group
- Interface Grouping
- USB Service
- Firewall
- MAC Filter
- Parental Control
- Scheduler Rule
- Certificates
- Log
- Traffic Status
- ARP Table
- Routing Table
- Multicast Status
- xDSL Statistics
- System
- User Account
- Remote Management
- SNMP
- Time Settings
- E-mail Notification
- Log Setting
- Firmware Upgrade
- Backup/Restore
- Diagnostic
- Troubleshooting
- Appendices
Chapter 8 Home Networking
VMG4825-B10A User’s Guide
118
If you click Static DHCP Configuration in the Static DHCP screen or the Edit icon next to a static
DHCP entry, the following screen displays.
Figure 50 Static DHCP: Static DHCP Configuration/Edit
The following table describes the labels in this screen.
8.4 The UPnP Screen
Universal Plug and Play (UPnP) is a distributed, open networking standard that uses TCP/IP for
simple peer-to-peer network connectivity between devices. A UPnP device can dynamically join a
network, obtain an IP address, convey its capabilities and learn about other devices on the network.
In turn, a device can leave a network smoothly and automatically when it is no longer in use.
See page 112 for more information on UPnP.
Table 30 Static DHCP: Static DHCP Configuration/Edit
LABEL DESCRIPTION
Active Select this to activate the connection between the client and the VMG.
Group Name Select the interface group name for which you want to configure static DHCP settings.
See Chapter 14 on page 174 for how to create a new interface group.
IP Type This field displays IPv4 for the type of the DHCP IP address. At the time of writing, it is
not allowed to select other type.
Select Device Info Select a device or computer from the drop-down list or select Manual Input to manually
enter a device’s MAC address and IP address in the following fields.
MAC Address If you select Manual Input, enter the MAC address of a computer on your LAN.
IP Address If you select Manual Input, enter the IP address that you want to assign to the
computer on your LAN with the MAC address that you will also specify.
OK
Click OK to save your changes.
Cancel Click Cancel to exit this screen without saving.