Operation Manual
Table Of Contents
- VMG4825-B10A
- User’s Guide
- Introducing the VMG
- The Web Configurator
- Quick Start
- Tutorials
- 4.1 Overview
- 4.2 Setting Up an ADSL PPPoE Connection
- 4.3 Setting Up a Secure Wireless Network
- 4.4 Setting Up Multiple Wireless Groups
- 4.5 Configuring Static Route for Routing to Another Network
- 4.6 Configuring QoS Queue and Class Setup
- 4.7 Access the VMG Using DDNS
- 4.8 Configuring the MAC Address Filter
- 4.9 Access Your Shared Files From a Computer
- Technical Reference
- Network Map and Status Screens
- Broadband
- Wireless
- Home Networking
- Routing
- Quality of Service (QoS)
- Network Address Translation (NAT)
- Dynamic DNS Setup
- VLAN Group
- Interface Grouping
- USB Service
- Firewall
- MAC Filter
- Parental Control
- Scheduler Rule
- Certificates
- Log
- Traffic Status
- ARP Table
- Routing Table
- Multicast Status
- xDSL Statistics
- System
- User Account
- Remote Management
- SNMP
- Time Settings
- E-mail Notification
- Log Setting
- Firmware Upgrade
- Backup/Restore
- Diagnostic
- Troubleshooting
- Appendices
Chapter 6 Broadband
VMG4825-B10A User’s Guide
65
6.2 The Broadband Screen
Use this screen to change your VMG’s Internet access settings. Click Network Setting >
Broadband from the menu. The summary table shows you the configured WAN services
(connections) on the VMG.
Figure 21 Network Setting > Broadband
The following table describes the labels in this screen.
6.2.1 Add/Edit Internet Connection
Click Add New WAN Interface in the Broadband screen or the Edit icon next to an existing WAN
interface to configure a WAN connection. The screen varies depending on the interface type, mode,
encapsulation, and IPv6/IPv4 mode you select.
Table 7 Network Setting > Broadband
LABEL DESCRIPTION
Add New WAN
Interface
Click this button to create a new connection.
# This is the index number of the entry.
Name This is the service name of the connection.
Type This shows whether it is an ATM, Ethernet or a PTM connection.
Mode This shows whether the connection is in routing or bridge mode.
Encapsulation This is the method of encapsulation used by this connection.
802.1p This indicates the 802.1p priority level assigned to traffic sent through this connection. This
displays N/A when there is no priority level assigned.
802.1q This indicates the VLAN ID number assigned to traffic sent through this connection. This
displays N/A when there is no VLAN ID number assigned.
IGMP Proxy This shows whether the VMG act as an IGMP proxy on this connection.
NAT This shows whether NAT is activated or not for this connection.
Default
Gateway
This shows whether the VMG use the WAN interface of this connection as the system default
gateway.
IPv6 This shows whether IPv6 is activated or not for this connection. IPv6 is not available when
the connection uses the bridging service.
MLD Proxy This shows whether Multicast Listener Discovery (MLD) is activated or not for this
connection. MLD is not available when the connection uses the bridging service.
Modify Click the Edit icon to configure the WAN connection.
Click the Delete icon to remove the WAN connection.