Users Manual Part 1

Chapter 1 Introducing the EMG

EMG6726/8726-B10A User’s Guide

1.4.3 Using the WPS Button

Once the WiFi LED turns green, the wireless network is active. If the wireless network is turned off, see

Section 7.2.1 on page 78 for how to enable the wireless network on the EMG.

You can also use the WPS button to quickly set up a secure wireless connection between the EMG and

a WPS-compatible client by adding one device at a time.

To activate WPS:

1 Make sure the POWER LED is on and not blinking.

2 Press the WPS button for more than five seconds and release it.

3 Press the WPS button on another WPS-enabled device within range of the EMG. The WiFi 2.4G and WiFi

5G LEDs flash amber while the EMG sets up a WPS connection with the other wireless device.

4 Once the connection is successfully made, the WPS LED shines green. Note that it depends on your

client’s configuration to have a 2.4GHz or 5GHz wireless network.

The WPS LED turns off when the wireless network is off.

1.4.4 Rear Panel

The following graphic displays the rear panel of the EMG.

WiFi 2.4G

WiFi 5G

Green On The 2.4 GHz or 5 GHz wireless network is activated.

Blinking The EMG is communicating with 2.4 GHz or 5 GHz wireless clients.

Amber Blinking The EMG is setting up a WPS connection with a 2.4 GHz or 5 GHz wireless

client.

Off The 2.4 GHz or 5GHz wireless network is not activated.

USB

Note: The USB LED is reserved for future development.

Phone1,

Phone2

Green On

A SIP account is registered for the phone port, and there’s no voice

message in the corresponding SIP account.

Blinking A telephone connected to the phone port has its receiver off of the hook or

there is an incoming call.

Amber On A SIP account is registered for the phone port and there is a voice message

in the corresponding SIP account.

Blinking A telephone connected to the phone port has its receiver off the hook and

there is a voice message in the corresponding SIP account.

Off The phone port does not have a SIP account registered.

Red On Registration to the network has failed.

WPS

Amber On WPS is enabled.

Off WPS is disabled.

Table 3 EMG8726-B10A LED Descriptions (continued)

LED COLOR STATUS DESCRIPTION