Users Manual Part 1

Chapter 4 Tutorials
EMG6726/8726-B10A User’s Guide
38
3 Select the Active check box. Enter the General and Account Information settings as provided above.
Set the Type to Ethernet.
Choose the Encapsulation specified by your service provider. For this example, the service provider
requires a username and password to establish Internet connection. Therefore, select PPPoE as the WAN
encapsulation type.
Set the IPv6/IPv4 Mode to IPv4 Only.
4 Enter the account information provided to you by your service provider.
5 Configure this rule as your default Internet connection by selecting the Apply as Default Gateway check
box. Then select DNS as Static and enter the DNS server addresses provided to you, such as 192.168.5.2
(DNS server1)/192.168.5.1 (DNS server2).
6 Leave the rest of the fields to the default settings.
7 Click Apply to save your settings.
Encapsulation PPPoE
IPv6/IPv4 Mode IPv4 Only
Account Information
PPP User Name [e-mail]
PPP Password ABCDEF!
Static IP Address 192.168.1.32
Others PPP Connection Trigger: Auto Connect
PPPoE Passthrough: Disable
NAT Enable: Enable
IGMP Proxy Enable: Enable
Apply as Default Gateway: Enable
VLAN Active: Disable