Users Manual Part 1

Chapter 4 Tutorials
EMG6726/8726-B10A User’s Guide
52
This tutorial uses the following example IP settings:
To configure a static route to route traffic from N1 to N2:
1 Log into the EMG’s Web Configurator in advanced mode.
2 Click Network Setting > Routing.
3 Click Add New Static Route in the Static Route screen.
4 Configure the Static Route Setup screen using the following settings:
4a Select the Active check box. Enter the Route Name as R.
4b Set IP Type to IPv4.
4c Type 192.168.10.0 and subnet mask 255.255.255.0 for the destination, N2.
4d Select Enable in the Use Gateway IP Address field. Type 192.168.1.253 (R’s N1 address) in the
Gateway IP Address field.
4e Select ETHWAN as the Use Interface.
Table 8 IP Settings in this Tutorial
DEVICE / COMPUTER IP ADDRESS
The EMG’s WAN 172.16.1.1
The EMG’s LAN 192.168.1.1
IP Type IPv4
Use Interface ETHWAN
A 192.168.1.34
R’s N1 192.168.1.253
R’s N2 192.168.10.2
B 192.168.10.33