Users Manual Part 1

Chapter 6 Broadband
EMG6726/8726-B10A User’s Guide
70
IPv4/IPv6 Mode Select IPv4 Only if you want the EMG to run IPv4 only.
Select IPv4 IPv6 DualStack to allow the EMG to run IPv4 and IPv6 at the same time.
Select IPv6 Only if you want the EMG to run IPv6 only.
PPP Information (This is available only when you select PPPoE in the Mode field.)
PPP User Name Enter the user name exactly as your ISP assigned. If assigned a name in the form user@domain
where domain identifies a service name, then enter both components exactly as given.
PPP Password Enter the password associated with the user name above. Select password unmask to show your
entered password in plain text.
PPP Connection
Trigger
Select when to have the EMG establish the PPP connection.
Auto Connect - select this to not let the connection time out.
On Demand - select this to automatically bring up the connection when the EMG receives
packets destined for the Internet.
Idle Timeout This value specifies the time in minutes that elapses before the router automatically disconnects
from the PPPoE server.
This field is not available if you select On Demand in the PPP Connection Trigger field.
PPPoE
Passthrough
This field is available when you select PPPoE encapsulation.
In addition to the EMG’s built-in PPPoE client, you can enable PPPoE pass through to allow up to
ten hosts on the LAN to use PPPoE client software on their computers to connect to the ISP via
the EMG. Each host can have a separate account and a public WAN IP address.
PPPoE pass through is an alternative to NAT for application where NAT is not appropriate.
Disable PPPoE pass through if you do not need to allow hosts on the LAN to use PPPoE client
software on their computers to connect to the ISP.
IP Address (This is available only when you select IPv4 Only or IPv4 IPv6 DualStack in the IPv4/IPv6 Mode field.)
Obtain an IP
Address
Automatically
A static IP address is a fixed IP that your ISP gives you. A dynamic IP address is not fixed; the ISP
assigns you a different one each time you connect to the Internet. Select this if you have a
dynamic IP address.
Static IP Address Select this option If the ISP assigned a fixed IP address
IP Address Enter the static IP address provided by your ISP.
Subnet Mask Enter the subnet mask provided by your ISP.
Gateway IP
Address
Enter the gateway IP address provided by your ISP.
VLAN
Active Select Enable to enable VLAN on this WAN interface.
802.1p IEEE 802.1p defines up to 8 separate traffic types by inserting a tag into a MAC-layer frame that
contains bits to define class of service.
Select the IEEE 802.1p priority level (from 0 to 7) to add to traffic through this connection. The
greater the number, the higher the priority level.
802.1q Type the VLAN ID number (from 1 to 4094) for traffic through this connection.
MTU
MTU Enter the MTU (Maximum Transfer Unit) size for this traffic.
Routing Feature (This is available only when you select IPv4 Only or IPv4 IPv6 DualStack in the IPv4/IPv6 Mode field.)
NAT Enable Select Enable to activate NAT on this connection.
Table 12 Network Setting > Broadband > Add New WAN Interface/Edit (Routing Mode) (continued)
LABEL DESCRIPTION