Users Manual Part 1

Chapter 7 Wireless
EMG6726/8726-B10A User’s Guide
82
7.4 The WPS Screen
Use this screen to use the WiFi Protected Setup (WPS) function on your EMG.
WPS allows you to quickly set up a wireless network with strong security, without having to configure
security settings manually. Set up each WPS connection between two devices. Both devices must
support WPS. See Section 7.8.8.2 on page 95 for more information about WPS.
Note: The EMG applies the security settings of the main 2.4G or 5G wireless profile (see Section
7.2.1 on page 78). If you want to use the WPS feature, make sure you have enabled
WPS in the Network Setting > Wireless > Advanced screen.
Click Network Setting > Wireless > WPS. The following screen displays.
Figure 34 Network Setting > Wireless > WPS
The following table describes the labels in this screen.
7.5 The Advanced Screen
Use this screen to configure advanced wireless settings. Click Network Setting > Wireless > Advanced.
The screen appears as shown.
See Section 7.8.2 on page 91 for detailed definitions of the terms listed in this screen.
Table 18 Network Setting > Wireless > WPS
LABEL DESCRIPTION
Connection Type This field indicates whether you will apply WPS to the 2.4G or 5G wireless network.
Wi-Fi Name This field displays the wireless network name.
WPS Click the Connect button to add another WPS-enabled wireless device (within wireless range of
the EMG) to the wireless network. This button may either be a physical button on the outside of
device, or a menu button similar to the WPS button on this screen.
Note: You must press the other wireless device’s WPS button within two minutes of
pressing this button.