Users Manual Part 2

Chapter 37 Diagnostic
EMG6726/8726-B10A User’s Guide
271
Figure 185 Maintenance > Diagnostic > 802.1ag
The following table describes the fields in this screen.
Table 130 Maintenance > Diagnostic > 802.1ag
LABEL DESCRIPTION
802.1ag Connectivity Fault Management
IEEE 802.1ag
CFM
Select Enable or Disable to activate or deactivate the IEEE802.1ag CFM (Connectivity Fault
Management) specification, which allows network administrators to identify manage
connection faults.
Y.1731 Select Enable or Disable to activate or deactivate Y.1731, which monitors Ethernet
performance.
Interface Select the interface on which you want to enable the IEE 802.1ag CFM.
Maintenance
Domain (MD)
Level
Select a level (0-7) under which you want to create an MA.
MEG ID Enter the Maintenance Entity Group Identifier. This identifies the MEG that the MEP belongs to.
MD Name Enter a descriptive name for the MD (Maintenance Domain).
MA ID Enter a descriptive name to identify the Maintenance Association.
802.1Q VLAN ID Type a VLAN ID (1-4094) for this MA.
Local MEP ID Enter the local Maintenance Endpoint Identifier (1~8191).
CCM Select Enable to continue sending MEP information by CCM (Connectivity Check Messages).
When CCMs are received the EMG will always process it, no matter if CCM is enabled or not.
Remote MEP ID Enter the remote Maintenance Endpoint Identifier (1~8191).
Test the connection to another Maintenance End Point (MEP)