Users Manual Part 2

Chapter 19 Parental Control
EMG6726/8726-B10A User’s Guide
197
The following table describes the fields in this screen.
Click Security > Parental Control > Add New PCP > Add New Service to open the following screen.
Figure 130 Parental Control Rule: Add/Edit Rule > Add New Service
Table 81 Parental Control Rule: Add/Edit
LABEL DESCRIPTION
General
Active Select to enable or disable this parental control rule.
Parental Control
Profile Name
Enter a descriptive name for the rule.
Home Network
User
Select the LAN user that you want to apply this rule to from the drop-down list box. If you select
Custom, enter the LAN user’s MAC address. If you select All, the rule applies to all LAN users.
Rule List In Home Network User, select Custom, enter the LAN user’s MAC address, then click the Add
icon to enter a computer MAC address for this PCP. Up to five are allowed. Click the Delete icon
to remove one.
Internet Access Schedule
Day Select check boxes for the days that you want the EMG to perform parental control.
Time Drag the time bar to define the time that the LAN user is allowed access (Authorized access) or
denied access (No access). Click the Add icon above the time bar to add a new time bar. Up
to three are allowed.
Network Service
Network Service
Setting
If you select Block, the EMG blocks access to all the network services listed below.
If you select Allow, the EMG blocks access to all the network services except ones listed below.
Add New
Service
Click this to show a screen in which you can add a new service rule. You can configure the
Service Name, Protocol, and Port of the new rule.
# This shows the index number of the rule.
Service Name This shows the name of the rule.
Protocol:Port This shows the protocol and the port of the rule.
Modify Click the Edit icon to go to the screen where you can edit the rule.
Click the Delete icon to delete an existing rule.
OK Click OK to save your changes.
Cancel Click Cancel to exit this screen without saving.