User's Guide

Chapter 3 Hardware
NWA/WAC/WAX Series User’s Guide
37
3.2.3 NWA1123-AC HD
The following are the LED descriptions for your NWA1123-AC HD.
Amber Blinks amber and green
alternatively 2 times and
then turns solid green for 3
seconds.
The Zyxel Device is managed by an AC but the uplink is
disconnected.
Green
Green Slow Blinking (On for 1
second, Off for 1 second)
The wireless module of the Zyxel Device is disabled or fails, the
Zyxel Device is in standalone mode and is using default
wireless settings, or the Zyxel Device is configured to be
managed by NCC but is not yet registered with the NCC.
Green Steady On The Zyxel Device is ready for use, the Zyxel Device’s wireless
interface is activated, and/or wireless clients are connected
to the Zyxel Device when it receives power using IEEE 802.3at
PoE plus (full power mode).
Amber Steady On The Zyxel Device ready for use, the Zyxel Device’s wireless
interface is activated, and/or wireless clients are connected
to the Zyxel Device when it receives power using 802.3af PoE
(limited power mode).
Bright Blue Steady On The Zyxel Device’s wireless interface is activated, but there
are no wireless clients connected when it receives power
using IEEE 802.3at PoE plus (full power mode).
White Steady On The Zyxel Device’s wireless interface is activated, but there
are no wireless clients connected when it receives power
using 802.3af PoE (limited power mode).
Slow Blinking (On for
100ms per second)
Locator LED is on. It switches off automatically after the
configured amount of time (1-60min). Default duration is 10
minutes.
Blue Slow Blinking (Blink for 1
time, Off for 1 second)
The Zyxel Device is performing a Channel Availability Check
(CAC) with Dynamic Frequency Selection (DFS) to monitor a
channel for radar signals.
Red On The Zyxel Device failed to boot up or is experience system
failure.
Fast Blinking (On for 50
milliseconds, Off for 50
milliseconds)
The Zyxel Device is undergoing firmware upgrade.
Slow Blinking (Blink for 3
times, Off for 3 seconds)
The Uplink port of the Zyxel Device in standalone mode is
disconnected.
Table 9 WAC6303D-S and NWA5123-AC HD LED (continued)
COLOR STATUS DESCRIPTION