User's Guide

Chapter 3 Hardware

NWA/WAC/WAX Series User’s Guide

3.3.2 NWA1302-AC

By default, the LEDs automatically turn on when the NWA1302-AC is ready. If the LEDs are turned off by

the NCC, you can press the LED ON button for one second to turn on the LEDs again. The LEDs will blink

and turn off after two minutes.

Figure 19 NWA1302-AC LEDs

The following table describes the LEDs.

Locator White Blinking The Locator is activated and will blink to show the actual

location of the Zyxel Device between several devices in the

network.

Off The Locator function is off.

Table 13 NWA1123-AC PRO LEDs (continued)

LED COLOR STATUS DESCRIPTION

Table 14 NWA1302-AC LEDs

LED COLOR STATUS DESCRIPTION

PWR/SYS Amber Blinks amber for 1

second and green for 1

second alternatively.

The LED blinks amber and green alternatively when the

Zyxel Device is booting up.

Green

Green On The Zyxel Device is ready for use.

Slow Blinking (On for 1

sec, Off for 1 sec)

The wireless module of the Zyxel Device is disabled or

failed, or the Locator LED is on.

Fast Blinking (On 50ms,

Off 50ms)

The Locator LED is on.

Red On There is a system error and the Zyxel Device cannot boot

up, or the Zyxel Device suffered a system failure.

Fast Blinking (On for 50

ms, Off for 50 ms)

The Zyxel Device is doing firmware upgrade.

Slow Blinking (Blink for 3

times, Off for 3 sec)

The Uplink interface is down.