Operation Manual

Chapter 10 Quality of Service (QoS)
VMG/XMG Series User’s Guide
213
10.6 The QoS Shaper Setup Screen
This screen lets you use the token bucket algorithm to allow a certain amount of large bursts of traffic
while keeping most outgoing traffic at the average rate. Click Network Setting > QoS > Shaper Setup.
The screen appears as shown.
Figure 128 Network Setting > QoS > Shaper Setup
The following table describes the labels in this screen.
802.1P Mark Select a priority level with which the Zyxel Device replaces the IEEE 802.1p priority field in the
packets.
If you select Unchange, the Zyxel Device keep the 802.1p priority field in the packets.
Step4: Class Routing
Forward to
Interface
Select a WAN interface through which traffic of this class will be forwarded out. If you select
Unchange, the Zyxel Device forward traffic of this class according to the default routing table.
Step5: Outgoing Queue Selection
To Queue Index Select a queue that applies to this class.
You should have configured a queue in the Queue Setup screen already.
Cancel Click Cancel to exit this screen without saving.
OK Click OK to save your changes.
Table 70 Classification Setup: Add/Edit (continued)
LABEL DESCRIPTION
Table 71 Network Setting > QoS > Shaper Setup
LABEL DESCRIPTION
Add New
Shaper
Click this to create a new entry.
# This is the index number of the entry.
Status This field displays whether the shaper is active or not. A yellow bulb signifies that this policer is
active. A gray bulb signifies that this shaper is not active.
Outgoing
Interface
This shows the name of the Zyxel Device's interface through which traffic in this shaper applies.
Rate Limit This shows the average rate limit of traffic bursts for this shaper.
Modify Click the Edit icon to edit the shaper.
Click the Delete icon to delete an existing shaper. Note that subsequent rules move up by one
when you take this action.