Operation Manual

Chapter 20 Parental Control
VMG/XMG Series User’s Guide
273
Figure 173 Security > Parental Control
The following table describes the fields in this screen.
20.2.1 Add/Edit a Parental Control Profile
Click Add new PCP in the Parental Control screen to add a new rule or click the Edit icon next to an
existing rule to edit it. Use this screen to configure a restricted access schedule and/or URL filtering
settings to block the users on your network from accessing certain web sites.
Table 107 Security > Parental Control
LABEL DESCRIPTION
General
Parental Control Select Enable to activate parental control.
Parental Control Profile(PCP)
Add new PCP Click this if you want to configure a new Parental Control Profile (PCP).
# This shows the index number of the rule.
Status This indicates whether the rule is active or not.
A yellow bulb signifies that this rule is active. A gray bulb signifies that this rule is not active.
PCP Name This shows the name of the rule.
Home Network
User MAC
This shows the MAC address of the LAN user’s computer to which this rule applies.
Internet Access
Schedule
This shows the day(s) and time on which parental control is enabled.
Network Service This shows whether the network service is configured. If not, None will be shown.
Website Block This shows whether the website block is configured. If not, None will be shown.
Modify Click the Edit icon to go to the screen where you can edit the rule.
Click the Delete icon to delete an existing rule.
Cancel Click Cancel to restore your previously saved settings.
Apply Click Apply to save your changes.