Operation Manual

Chapter 28 Routing Table
VMG/XMG Series User’s Guide
330
The following table describes the labels in this screen.
Table 143 System Monitor > Routing Table
LABEL DESCRIPTION
IPv4/IPv6 Routing Table
Destination This indicates the destination IPv4 address or IPv6 address and prefix of this route.
Gateway This indicates the IPv4 address or IPv6 address of the gateway that helps forward this route’s
traffic.
Subnet Mask This indicates the destination subnet mask of the IPv4 route.
Flag This indicates the route status.
U-Up: The route is up.
!-Reject: The route is blocked and will force a route lookup to fail.
G-Gateway: The route uses a gateway to forward traffic.
H-Host: The target of the route is a host.
R-Reinstate: The route is reinstated for dynamic routing.
D-Dynamic (redirect): The route is dynamically installed by a routing daemon or redirect.
M-Modified (redirect): The route is modified from a routing daemon or redirect.
Metric The metric represents the "cost of transmission". A router determines the best route for
transmission by choosing a path with the lowest "cost". The smaller the number, the lower the
"cost".
Interface This indicates the name of the interface through which the route is forwarded.
brx indicates a LAN interface where x can be 0~3 to represent LAN1 to LAN4 respectively.
ptm0 indicates a VDSL WAN interface using IPoE or in bridge mode.
ethx indicates an Ethernet WAN interface using IPoE or in bridge mode.
ppp0 indicates a WAN interface using PPPoE.
wlx indicates a wireless interface where x can be 0~1. For VMG4927-B10A, wl1 indicates 5 GHz
wireless interface, and wl0 indicates 2.4 GHz wireless interface. For the other models, wl1
indicates 5 GHz wireless interface, and wl0 indicates 2.4 GHz wireless interface.