Operation Manual

Chapter 1 Introducing the Zyxel Device
VMG/XMG Series User’s Guide
52
1.4.3.1 Transceiver Installation
Use the following steps to install an SFP transceiver.
1 Locate the transmit (Tx) and the receive (Rx) markings on the SFP+ module to identify the top.
2 Insert the transceiver into the slot.
3 Press the transceiver firmly until it clicks into place.
4 The Zyxel Device automatically detects the installed transceiver. Check the LEDs to verify that it is
functioning properly.
5 Close the transceiver’s latch (the latch styles vary).
6 Connect the fiber optic cables to the transceiver.
1.4.3.2 Transceiver Removal
Use the following steps to remove an SFP transceiver.
1 Remove the fiber optic cables from the transceiver.
2 Open the transceiver’s latch (the latch styles vary).
3 Pull the transceiver out of the slot.
1.4.4 Using the WLAN and WPS Buttons
If the wireless network is turned off, press the WiFi button. Check the WLAN/WPS LED on the front panel to
see if the wireless network is active.
You can also use the WPS button to quickly set up a secure wireless connection between the Zyxel
Device and a WPS-compatible client by adding one device at a time.
To activate WPS:
1 Make sure the POWER LED is on and not blinking.
2 Press the WPS button and release it.
USB The USB port(s) is used for cellular WAN backup, file-sharing, media server, and print server.
DSL Connect a RJ-11 cable to the DSL port for Internet access.
PHONE1 ~
PHONE2
Connect analog phones to the phone ports to make phone calls.
LAN1 ~ LAN4 Connect computers or other Ethernet devices to Ethernet ports for Internet access.
WAN Connect an Ethernet cable to the Ethernet WAN port for Internet access.
Power Connect the power cable and then can press the power button to start the device.
Reset Press the button to return the Zyxel Device to the factory defaults.
Table 15 Panel Ports and Buttons (continued)
LABEL DESCRIPTION