User's Manual

Chapter 7 Wireless Security Screen
NWA1100-N User’s Guide
80
The following table describes the labels in this screen.
7.4.4 Security: WPA, WPA2 or WPA2-MIX
This screen varies depending on whether you select Access Point, Multi SSID or Wireless Client
in the Wireless > Wireless Settings screen.
Table 17 Security: 802.1x + Static WEP for Wireless Client
LABEL DESCRIPTION
Security Settings
Profile Name This is the name that identifying this profile.
Security Mode Choose the same security mode used by the AP.
Data Encryption Select 64-bit WEP, 128-bit WEP or 152-bit WEP to use 802.1x authentication with a
static WEP key.
Passphrase Enter the passphrase or string of text used for automatic WEP key generation.
Generate Click this to get the keys from the Passphrase you entered.
Key 1 to
Key 4
The WEP keys are used to encrypt data. Both the NWA and the wireless device to which
the NWA is connecting must use the same WEP key for data transmission.
If you chose 64-bit WEP, then enter any 5 ASCII characters or 10 hexadecimal
characters ("0-9", "A-F").
If you chose 128-bit WEP, then enter 13 ASCII characters or 26 hexadecimal characters
("0-9", "A-F").
If you chose 152-bit WEP, then enter 16 ASCII characters or 32 hexadecimal characters
("0-9", "A-F").
You must configure all four keys, but only one key can be activated at any one time.
IEEE802.1x Authentication
EAP Type The options on the left refer to EAP methods. You can choose either TLS, LEAP, PEAP or
TTLS.
The options on the right refer to authentication protocols. You can choose between
MSCHAPv2 and GTC.
User Information
Username Supply the username of the account created in the RADIUS server.
Password Supply the password of the account created in the RADIUS server.
Apply Click Apply to save your changes.
Reset Click Reset to begin configuring this screen afresh.
Back Click Back to return to the previous screen.