User's Manual

Chapter 15 Static Route
NBG-417N User’s Guide
134
15.3 IP Static Route Screen
Use this screen to view existing static route rules. Click Management > Static Route to open the
IP Static Route screen. The following screen displays.
Figure 80 Management > Static Route > IP Static Route
The following table describes the labels in this screen.
Table 53 Management > Static Route > IP Static Route
LABEL DESCRIPTION
# This is the index number of an individual static route. The first entry is for the
default route and not editable.
Name This is the name that describes or identifies this route.
Active This icon is turned on when this static route is active.
Click the Edit icon under Modify and select the Active checkbox in the Static
Route Setup screen to enable the static route. Clear the checkbox to disable
this static route without having to delete the entry.
Destination This parameter specifies the IP network address of the final destination. Routing
is always based on network number.
Gateway This is the IP address of the gateway. The gateway is an immediate neighbor of
your NBG-417N that will forward the packet to the destination. On the LAN, the
gateway must be a router on the same segment as your NBG-417N; over the
WAN, the gateway must be the IP address of one of the remote nodes.
Modify Click the Edit icon to open the static route setup screen. Modify a static route or
create a new static route in the Static Route Setup screen.
Click the Remove icon to delete a static route.