User's Manual

Chapter 4 Connection Wizard
NBG-417N User’s Guide
39
The following table describes the labels in this screen.
4.4 Connection Wizard: STEP 3: Internet Configuration
The NBG-417N offers three Internet connection types. They are Ethernet, PPP over Ethernet or
PPTP. The wizard attempts to detect which WAN connection type you are using. If the wizard does
not detect a connection type, you must select one from the drop-down list box. Check with your ISP
to make sure you use the correct type.
This wizard screen varies according to the connection type that you select.
Figure 15 Wizard Step 3: ISP Parameters.
The following table describes the labels in this screen,
Table 10 Wizard Step 2: Extend (WPA-PSK or WPA2-PSK) Security
LABEL DESCRIPTION
Pre-Shared
Key
Type from 8 to 63 case-sensitive ASCII or HEX characters. You can set up the most
secure wireless connection by configuring WPA in the wireless LAN screens. You need
to configure an authentication server to do this.
Back Click Back to display the previous screen.
Next Click Next to proceed to the next screen.
Exit Click Exit to close the wizard screen without saving.
Table 11 Wizard Step 3: ISP Parameters
CONNECTION TYPE DESCRIPTION
Ethernet Select the Ethernet option when the WAN port is used as a regular
Ethernet.
PPPoE
Select the PPP over Ethernet option for a dial-up connection. If your ISP
gave you an IP address and/or subnet mask, then select PPTP.
PPTP Select the PPTP option for a dial-up connection.