User's Manual

Chapter 6 Tutorials
NBG-417N User’s Guide
59
6.2.2 Enable and Configure Wireless Security without WPS on your NBG-
417N
This example shows you how to configure wireless security settings with the following parameters
on your NBG-417N.
Follow the steps below to configure the wireless settings on your NBG-417N.
The instructions require that your hardware is connected (see the Quick Start Guide) and you are
logged into the Web Configurator through your LAN connection (see Section 3.2 on page 25).
1 Open the Wireless LAN > General screen in the NBG-417N’s Web Configurator.
2 Make sure the Enable Wireless LAN check box is selected.
3 Enter SSID_Example3 as the SSID and select a channel.
4 Set security mode to WPA-PSK and enter ThisismyWPA-PSKpre-sharedkey in the Pre-Shared
Key field. Click Apply.
Figure 31 Tutorial: Network > Wireless LAN > General
SSID SSID_Example3
Channel 6
Security WPA-PSK
(Pre-Shared Key: ThisismyWPA-PSKpre-sharedkey)