User's Manual

Chapter 5 Tutorials
NBG-418N User’s Guide
58
5.2.1.1 Push Button Configuration (PBC)
1 Make sure that your NBG-418N is turned on and that it is within range of your computer.
2 Make sure that you have installed the wireless client (this example uses the NWD210N) driver and
utility in your notebook.
3 In the wireless client utility, find the WPS settings. Enable WPS and press the WPS button (Start or
WPS button)
4 Log into NBG-418N’s Web Configurator and press Push Button in the Network > Wireless LAN >
WPS Station screen.
Note: Your NBG-418N has a WPS button located on its panel, as well as a WPS button in
its configuration utility. Both buttons have exactly the same function; you can use
one or the other.
Note: It doesn’t matter which button is pressed first. You must press the second button
within two minutes of pressing the first one.
The NBG-418N sends the proper configuration settings to the wireless client. This may take up to
two minutes. Then the wireless client is able to communicate with the NBG-418N securely.
The following figure shows you an example to set up wireless network and security by pressing a
button on both NBG-418N and wireless client (the NWD210N in this example).