User's Manual

NBG4615 User’s Guide 237
APPENDIX A
Product Specifications
The following tables summarize the NBG4615’s hardware and firmware features.
Table 91 Hardware Features
Dimensions 162 mm (W) x 106 mm (D) x 28 mm (H)
Weight 285g
SDRAM 32 MB
Flash Memory 8 MB
Power Specification Input: 100~240 AC, 50~60 Hz
Output: 12 V DC 1.5A
Ethernet ports Auto-negotiating: 100 Mbps, 1000 Mbps in either half-duplex or full-
duplex mode.
Auto-crossover: Use either crossover or straight-through Ethernet cables.
Built-in Switch You can use either straight-through or crossover Ethernet cables (MDI/
MDI-X support) to connect multiple computers or servers (for example,
game servers) in your network to the NBG4615.
LEDs Power, LAN1-4, WAN, Internet/WPS, USB1-2
Reset button The reset button is built into the rear panel. Use this button to restore the
NBG4615 to its factory default settings. Press for 1 second to restart the
device. Press for 5 seconds to restore to factory default settings.
WPS button Press the WPS on two WPS enabled devices within 120 seconds for a
security-enabled wireless connection.
Power switch Turn on or turn off the power of the NBG4615 using this switch.
WLAN switch Turn on or turn off the wireless function of the NBG4615 using this switch.
There is no need to go into the Web Configurator.
Antenna The NBG4615 is equipped with two 2dBi (2.4GHz) detachable antenna to
provide clear radio transmission and reception on the wireless network.
USB Port The NBG4615 has two built-in USB 2.0 type A for USB device connectivity
and supports 3G USB dongle.
Operation Environment Temperature: 0º C ~ 40º C / 32ºF ~ 104ºF
Humidity: 10% ~ 90%
Storage Environment Temperature: -30º C ~ 70º C / -22ºF ~ 158ºF
Humidity: 10% ~ 95%
Table 92 Firmware Features
FEATURE DESCRIPTION
Default LAN IP Address 192.168.1.1 (router)
192.168.1.2. (AP)
Default LAN Subnet Mask 255.255.255.0 (24 bits)