User's Manual

Chapter 1 Getting to Know Your NSA
NSA-2401 User’s Guide
33
1.1.2 Power Button
Press the power button on the front panel to turn the NSA on and off.
• To turn the NSA on: press the power button and release it.
• To turn the NSA off, press the power button in and hold it until you hear a beep. Then
release the button. The SYS light blinks red until the NSA is shut down.
• If the above shut-down procedure does not work (which may happen if the NSA has
crashed), hold the power button in a few more seconds until you hear a second beep. The
NSA turns off immediately.
1.1.3 COPY Button
Use the COPY button on the front panel to copy files from a connected USB device to the
NSA. Use the Applications > Copy Button screen (Section 10.4 on page 227) to choose
where the NSA stores the files. The name of the folder created for the copied files consists of
the date and time of the copy in year_month_day_hour_minute_second format.
SYS Red On The NSA has passed system tests.
Blinking The NSA is starting up or shutting down.
Quick blinking indicates a RAID array is in degraded mode.
Orange On The NSA is unlocking an encrypted volume or there are no
volumes in the NSA.
Blinking Firmware is being uploaded to the NSA.
Green On The NSA has fully booted and is operating normally.
LAN1/LAN2 Green Off The LAN is not connected.
On The NSA has a successful 10/100 Mbps Ethernet
connection.
Blinking The 100M LAN is sending or receiving packets.
Orange On The NSA has a successful 1000 Mbps Ethernet connection.
Blinking The 1000M LAN is sending or receiving packets.
COPY Green On A USB device is connected to the NSA.
Blinking The NSA is copying files from the USB device.
Red On Copying files from the USB device failed. Press the COPY
button to set the COPY LED back to green.
Off No USB device is connected.
Table 2 NSA LEDs (continued)
LED COLOR STATUS DESCRIPTION