User's Manual

Chapter 10 Quality of Service (QoS)
P-663HN-51 User’s Guide
108
10.4 Adding a Queue
Click Advanced > Quality of Service > Queue Configuration > Add to open
the following screen. Use this screen to configure a QoS queue. A QoS queue sets
the priority used for incoming packets that the QoS classifier has grouped into a
flow.
Note: You can only add QoS queues for WAN interfaces that have QoS enabled.
Figure 50 Advanced > Quality of Service > Queue Configuration > Add
The following table describes the labels in this screen.
Table 37 Advanced > Quality of Service > Queue Configuration > Add
LABEL DESCRIPTION
Queue
Configuration
Status
Select Enable to turn on this queue.
Queue Select the WAN connection’s DSL port, Virtual Path Identifier, and
Virtual Channel Identifier.
Description This field displays any extra configured identification information.
Queue
Precedence
Set the queue’s priority relative to the other queues. The lower the
number, the higher the priority. 1 is the highest priority. 4 is the
lowest.
Save/Apply Click this button to save the changes and have the ZyXEL Device start
using them.