User's Manual

Chapter 10 Quality of Service (QoS)
P-663HN-51 User’s Guide
110
10.5.1 Configuring a QoS Class
Click Advanced > Quality of Service > QoS Classification and then the Add
or Edit button to configure a classifier. There are two sets of classification rules.
Set-1 is based on different fields within the TCP/UDP/IP layer plus the physical
Dest. Addr./Mask This is the IP address (and optionally the subnet mask) of the device
that the traffic is going to.
Dest. Port This is the port number on a device to which the traffic is going.
Source MAC
Addr./Mask
This is the MAC address (and optionally the subnet mask) of the
device that sent the traffic.
Dest. MAC Addr./
Mask
This is the MAC address (and optionally the subnet mask) of the
device that the traffic is going to.
802.1P This is the IEEE 802.1p mark on the traffic.
Order This is the classifier’s place in the classifiers list.
Enable / Disable The classifier is active when this check box is selected.
Remove To remove an entry, select its Remove check box and click the
Remove button.
Add Click this button to go to a screen where you can configure settings for
a new QoS queue.
Remove To remove an entry select its Remove check box and click the
Remove button.
Save/Apply Click this button to save the changes and have the ZyXEL Device start
using them.
Table 38 Advanced > Quality of Service > QoS Classification (continued)
LABEL DESCRIPTION