User's Manual

Chapter 11 Routing
P-663HN-51 User’s Guide
117
11.3 Configuring Static Route
Click Advanced > Routing > Static Route to open the Static Route screen.
Figure 55 Advanced > Routing > Static Route
The following table describes the labels in this screen.
11.3.1 Static Route Add
Click Advanced > Routing > Static Route > Add to open the following screen.
Use this screen to configure the required information for a static route.
Figure 56 Advanced > Routing > Static Route > Add
Table 41 Advanced > Routing > Static Route
LABEL DESCRIPTION
Destination This parameter specifies the IP network address of the final destination.
Routing is always based on network number.
Subnet Mask This is the IP subnet mask.
Gateway This is the IP address of the gateway. The gateway is a router or switch
on the same network segment as the device's LAN or WAN port. The
gateway helps forward packets to their destinations.
Interface If the static route should send traffic through a specific ZyXEL Device
interface, it displays here.
Remove To remove an entry, select its Remove check box and click the Remove
button.
Add Click this button to go to a screen where you can configure settings for a
new static route.
Remove To remove an entry select its Remove check box and click the Remove
button.