User's Manual

Chapter 18 Wireless LAN
P-663HN-51 User’s Guide
149
Push Button Select this to use the PBC (Push Button Configuration) method to send
the ZyXEL Device’s wireless settings to your wireless stations.
Click Add Enrollee to start WPS-aware wireless station scanning and
the wireless security information synchronization.
Note: After you click Add Enrollee, you have 2 minutes to click a
similar button in the wireless station’s utility.
After the WPS process finishes (the enrollee is able to access the
ZyXEL Device) you can click Add Enrollee again to add another
wireless station. Then click the WPS button in the second wireless
station’s utility. You can keep repeating this process to add more
wireless clients one at a time.
PIN Select this to use the PIN configuration method to configure a wireless
station’s wireless settings. Enter the PIN of the device that you are
setting up a WPS connection with and click Add Enrollee to
authenticate and add the wireless device to your wireless network.
You can find the PIN either on the outside of the device, or by
checking the device’s settings.
Note: You must also activate WPS on the other device within two
minutes to have it present its PIN to the ZyXEL Device.
WPS AP Mode Configured uses the ZyXEL Device’s current wireless security settings
for WPS.
Note: If the ZyXEL Device’s wireless security is set to Open,
selecting Configured and using WPS sets up a wireless
network with no security.
Unconfigured has the ZyXEL Device change its wireless security
settings when you do one of the following:
• Add a wireless enrollee. The ZyXEL Device automatically uses
WPA2-PSK and a random key. The WPS AP Mode automatically
changes to Configured.
•Use Setup AP to have an external registrar (like Windows Vista)
configure the ZyXEL Device’s wireless security settings. The WPS
AP Mode automatically changes to Configured.
• Manually configure the ZyXEL Device’s wireless security settings.
Then you can manually set the WPS AP Mode to Configured.
Setup AP This is available when you set the WPS AP Mode to Unconfigured.
Click Config AP to have an external registrar configure the ZyXEL
Device’s wireless security settings. See Section 18.10.5 on page 170
for how to use Windows Vista as an external registrar. Push Button
and PIN are reserved for future use and have no effect at the time of
writing.
Note: After you click Config AP you must enter the ZyXEL
Device’s PIN in the external registrar within two minutes.
Table 54 Wireless > Security
LABEL DESCRIPTION