User's Manual

Chapter 5 WAN Setup
P-663HN-51 User’s Guide
70
5.14 Bridge WAN Connection Setup
When you select bridge in the second WAN setup add (or edit) screen, this screen
displays next. Use this screen to configure bridge connection settings.
Figure 29 Advanced Setup > WAN > Add (3: Bridge)
The following table describes the labels in this screen.
5.15 IGMP Multicast
Traditionally, IP packets are transmitted in one of either two ways - Unicast (1
sender - 1 recipient) or Broadcast (1 sender - everybody on the network).
Use the following
default gateway
The default is a neighboring router that helps the ZyXEL Device
forward traffic to its destination. Select this option and enter the
gateway’s IP address or select the WAN interface to use to connect to
it.
Use the following
DNS server
addresses
The ZyXEL Device uses a DNS server to resolve a domain name (find
the numeric IP address associated with the domain name). Select this
option. Enter the DNS server addresses from the ISP in the fields
below.
Back Click this to return to the previous screen.
Next Click this to go to the following screen.
Table 18 Advanced Setup > WAN > Add (3: IPoA) (continued)
LABEL DESCRIPTION
Table 19 Advanced Setup > WAN > Add (3: Bridge)
LABEL DESCRIPTION
Enable Bridge
Service
Select this to turn on bridging for this DSL connection.
Service Name If the ISP specified a service name to use for the DSL connection,
enter it here. Otherwise leave the default generated text.
Back Click this to return to the previous screen.
Next Click this to go to the following screen.