User's Manual

Chapter 8 Security
P-663HN-51 User’s Guide
96
8.4 Adding Incoming IP Filtering Rules
To add an incoming IP filtering rule, click Advanced Setup > Security > IP
Filtering > Incoming > Add. The screen appears as shown.
Figure 45 Advanced Setup > Security > IP Filtering > Incoming > Add
The following table describes the labels in this menu.
Add Click this button to go to a screen where you can configure settings for a
new entry.
Remove To remove a WAN connection, select its Remove check box and click the
Remove button.
Table 30 Advanced Setup > Security > IP Filtering > Incoming
LABEL DESCRIPTION
Table 31 Advanced Setup > Security > IP Filtering > Incoming > Add
LABEL DESCRIPTION
Filter Name Type the name configured to identify the filter entry.
Protocol Select the type of packets to which this entry applies (TCP, UDP, or
both).
Source IP
Address
Type the IP address of a computer on the Internet to which this entry
applies.
Source
Subnet Mask
Type the subnet mask of a computer on the Internet to which this entry
applies.
Source Port Type the source port for traffic (from the Internet) to which this entry
applies.