User's Manual

Chapter 3 Tutorials
ADSL Series User’s Guide
42
2 You can either modify the default ADSL WAN interface by clicking the Edit icon or create a new
WAN interface (if you want to keep the default one). This example creates a new WAN interface.
Click Add new WAN Interface.
Note: You can create multiple ADSL WAN interfaces, however, only one of them is active
at one time. The Default Gateway field in the table indicates the interface is
active (Yes) or not (No).
3 For this example, the interface type is ADSL and the connection has the following information.
General
Name MyDSLConnection
Type ADSL
Mode Routing
WAN Service Type PPP over Ethernet (PPPoE)
ATM PVC Configuration
VPI/VCI 36/48
Encapsulation
Mode
LLC/SNAP-BRIDGING
Service Category UBR without PCR
PPP Information
PPP User Name [e-mail]
PPP Password ABCDEF!
PPPoE Service
Name
My DSL
Authentication
Method
Auto
Static IP Address Put a check on the option Use Static IP Address.
Use 192.168.1.32 as the IP Address.
Others PPPoE Passthrough: Disabled
NAT: Enabled
IGMP Proxy: Enabled
Apply as Default Gateway: Enable
DNS Server: Static DNS IP Address (Primary: 192.168.1.254
Secondary: 192.168.1.253)